1967 Evinrude StarFlite 80 HP Outboards Service Manual, PN 4359, Page 18Get this manual
CARBURETOR BODY aDrain the carburetor by removing the drain screws from the carburetor bodySee Figure 3-9bRemove orifice plugsTo prevent damaging threads in carburetor body, use fixed jet screwdriver (Special Tool #379664)See Figure 3-10cRemove air intake screensd Mark choke cover so that correct setting is retained in reassemblyRemove choke cover by removing three screwsRemove choke solenoid and plungere The threaded ends of the choke and throttle valve attaching screws are staked during assembly to prevent loss during operati onNOTE Under normal conditions removal of choke and throttle valves is not necessarySee "Cleaning, Inspection, and Repair" for service instructions FLOAT AND NEEDLE VALVES aSeparate the carburetor cover from the carburetor body by removing ten screwsSee Figure 3-11bRemove nylon hinge pin to permit removal of float and float arm assembly Remove float valve,