1965 Evinrude SportFour Heavy Duty 60 HP Outboards Service Manual, 4204, Page 79Get this manual
fMeasure new rope and cut to length of 69-3 inches Singe both ends of rope to length of 1 inch to fuse nylon fibersRope ends must be stiff to hold properly in pulley and rope anchor SPEC IAL TOOL #3 78774
gTie knot in rope and thread through hole in pulley and guide hole in housingLubricate handle end of rope and install handle, using Evinrude Starter Rope Threading Tool (Special Tool378774) See Figure 8-8Lay rope into channel in rope anchor with stiff end of rope butted against end of channelPress anchor into handlehRemove pin and allow pulley to recoil slowly Install spindle friction spring and pawl and secure with retaining ringiCheck action of pawl by pulling rope handleWhen rope is pulled, pawl should extendWhen rope is released, pawl should retractSTARTER ROPE HANDLE