1965 Evinrude SportFour Heavy Duty 60 HP Outboards Service Manual, 4204, Page 42Get this manual
bDisconnect all electrical connections from motor cable, including ignition, safety switch, and starter leadsIdentify leads to assure correct reassemblycRemove front lower motor cover, and rear exhaust housing cover with rear lower motor coverdRemove carburetor, leaf valve assembly, fuel pump, and fuel lines as described in Section 3eRemove manual starter as described in Section 7fUsing an appropriate flywheel holding fixture, remove flywheel attaching nutRemove flywheel, using puller (Special Tool #378103)See Figure 5-6 II:
Figure 5-8 Removing Power Head Nuts head must be placed on bench so that crankshaft is horizontal and crankcase is facing up Weight of power head should be supported by the four bosses on the four cylinders
DISASSEMBL OF POWER HEAD
aDrive two taper pins out of crankcase and cylinder block assemblyDrive from back of crankcase toward frontSee Figure 5-9Remove six large and eight small screws attaching crankcase to cylinder blockFigure 5-6 Removing Flywheel with Puller gRemove magneto as described in Section 4Remove starter motor with Bendix drive as described in Section 7hDisconnect thermostat hosesiRemove six nuts and six screws attaching power