1965 Evinrude SportFour Heavy Duty 60 HP Outboards Service Manual, 4204, Page 21Get this manual
eAttach the high-speed venturi assemblies to the carburetor body, using venturi locating gage (Special Tool #379242) to assure correct positioning for optimum performanceSee Figure 3-23fCheck operation of the choke to be sure valves correctly shut off air flowExcessive air leakage around the edges of the valves will cause improper functioning of the choke 5454
Figure 3-24Float Level eReplace high- speed control gear and coverHigh-speed needles will be adjusted after the carburetor has been completely reassembled and installed on the motor CHOKE AND CHOKE SOLENOID aCheck the choke for free operationChoke valves must move freely, without bindingbAttach choke arm to choke shaft, and install choke solenoid and springcAdjust position of choke solenoid so that valves close when plunger bottoms in solenoidClosed end of solenoid should be approximately flush with bossSee Figure 3-25With choke knob pulled all the way out, choke shaft should have 1 16" free movement