Honda Outboards BF40A/BF50A Service Manual, Page 381Get this manual
16ELECTRICAL EQUIPMENT 1COl UNIT
2POWER COIL 4INDICATOR
BF40A-BF50A
3ECT (Engine Coolant Temperature) SENSOR
1COl UNIT
aINSPECTION
Measure the resistance between the terminals and be sure that the measurements conform to the ranges shown in the table below Use tester that is equivalent to or higher than the
performance specified; Internal resistance: 20 knNOC, 9I(J.NAC Be careful not to touch the metallic part of the tester probe with your body, otherwise correct resistance value cannot be obtained Read the tester manufacturer's operation instructions carefully before operation with testerBe sure the tester's battery is fully charged and check the meter before using the testert Use scale of an commercially available multi meter, and meter shows current flowing from negative (-) to positive (+)
14 (Not used)
[2] unit: kn
[3] Tester probe (+)
500-0050000 1360
5000026
60300 100400 1145
100400 34150
1980 100500
100400 60300