Honda Outboards BF40A/BF50A Service Manual, Page 379Get this manual

Honda Outboards BF40A/BF50A Service Manual, Page 379

BF40A-BF50A
dINSTALLATION
1) Install the long tiller handle assembly to the motor2) Install the 10 mm washers and tighten the 10 mm self-locking nuts to the specified torqueTORQUE: 34 N-m (3.5 kgf-m, 25 Ibf-ft)

3) Pass the long tiller handle wire harness through the under case grommet, and secure it with the wire harness clamp4) Set the control cable setting plate into the groove of the under case
[2] SHIFT CABLE

THROTILE CABLE

5) Pass the control cables through the under case grommet and set the control cables by aligning the groove of the control cable with the cutout of the control cable setting plate6) Adjust the control cables (throttle control cable length:

Back to Honda Outboards BF40A/BF50A Service Manual