Honda Outboards BF40A/BF50A Service Manual, Page 196Get this manual
HONDABF35A45A bDISASSEMBLYIREASSEMBLY
SNAP RING DISASSEMBLY: Hold the armature upright, place an offset wrench over the stopper piece and push the stopper piece down exposing the snap ringRemove the snap ring; then remove the stopper piece and clutch [1 )-1
OVERRUNNING CLUTCH
[4] 6003 BALL BEARING
(6] WASHER (2)
STOPPER COLLAR
STARTER MAGNETIC SWITCH CABLE REASSEMBLY: Connect the starter magnetic switch cable at the angle of 45 from the vertical line as shown
REASSEMBLYCheck for smooth movement in axial direction by rotating the clutchCheck the gear teeth for wear or damage; replace if necessaryAlso, check the flywheel ring gear teeth if the pinion gear teeth are d",maoAri