Honda Outboards BF40A/BF50A Service Manual, Page 179Get this manual
HONDABF35A45A
REMOTE CONTROL CABLE INSTALLATION
REMOTE CONTROL BOX SIDE
1) Remove the two screws and housing C
[1] 25 mm TAPPING SCREW (2)
2) Screw the lock nuts and eye ends more than mm (0.3 in)
onto the thread of the remote control cable and tighten the lock nut securely to hold the pivotApply marine grease to the hole of the eye end
[1] CONTROL CABLE
(3] (MARINE GREASE) (5] LOCK NUT
3) Install the shift control cable by aligning the groove of the control cable with the cable guide plateThen connect the eye end to the shift arm pin using the two washers and mm lock pin 4) Install the cable clamp spacer and throttle control cable by