Honda BF9.9A-BF15A Outboard Motors Shop Manual., Page 64Get this manual
HONDA 9) Remove 12 mm flange bolt and disconnect the
starting cable body groundRemove the wire harness from the cable clip
BODY GROUND
[2] CABLE CLIP
10) Remove seven 40 mm hexbolts, raise the engine and
remove itINSTALLATION
Installation is the reverse order of removalNote the followingOn engine installation, take care not to dislocate the coupling seal spring with the crankshaft endBe sure not pinch the oil tube of the oil filter with the oil case flangesBe sure to install the grommet on the neutral starting bracket when you insert the wire harness through the bracketRefer to pages 1-6 and 1-8 for the connector locations in the connector brackets and BRefer to page 7-4 for the wire harness body ground angleAfter installing the engine, adjust; Neutral starting cable (Pa3-5) Throttle rod (P3-6)Shift rod (P 3-61