Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 397Get this manual
OPERATION CHECK AFTER INSTALLATION
NOTE: Before checking the operation of the remote control cable, make sure that the cable is correctly adjusted and that there are no kinks and sharp bends in the cableOperate the remote control lever and check that the control cable should be moved smoothly1Move the control lever to the first stop on the forward (F) side (about 30 degrees), check that the shift shaft is in the forward position, 2Then move the control lever to the full throttle position at forward side, check that the carburetor throttle lever is in the fully-open position
OPTIONAL EQUIPMENT
RADIO UNIT INSTALLATION NOTE: Radio wave is strong that it may damage the outboard motorCarefully follow the installation instruction1Keep the antenna and the radio unit at least 50 cm (1.6 ft)
away from the outboard motor, control cable and remote control box2Do not install the antenna cord and control cable tied UP-
3Select radio with its output power less than 10 WGOOD
3Returning the control lever to the neutral position (N), check that the carburetor throttle lever moves to the fully-closed position4If this is not the case, readjust the throttle pivot shaft on the outboard motor side