Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 393Get this manual
OUTBOARD MOTOR SIDE
aREMOTE CONTROL CABLE
NOTE: After installing the control cable to the remote control box, install the control cable to the outboard motorConnect the control cable to the outboard motor with the remote control lever in "F" (FORWARD) full throttle position and free acceleration lever in fully closed position (idle)1Remove the engine cover
5 mm SCREW-WASHER
2Remove the mm screw-washer and move the Rengine under cover outside about 10 mm (0.4 in)Take care not to damage the cover moving too much3Temporary install the lock nut and shift pivot on each cable