Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 372Get this manual
bINSTALLATION Installation is the reverse order of removalRoute the power tilt switch wire along the main wire harnessWrap the wires with the lower spiral protector (shorter) starting from the branch point of the main wire harness as shownCover the motor and switch wire with the corrugated protector and set it in the place as shownSecure the wires covered with the spiral protector with the wire clamp (two places) and wire band clip (one place)Secure the power tih switch and motor wire with the wire band clip at the center of the marking tape points as shown11I
CORRUGATED PROTECTOR
131SPIRAL PROTECTOR Put the spiral protector to the power tilt relay mount rubber as shown