Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 360Get this manual
16)Apply ATF to new O-ring, and install it on the power tilt motor assembly17)Install the oil tank on the power tilt motor assembly so that the oil hole cap bolt mounting hole is at the motor wire side18)Set the wire band clip on the clip bracket, and secure the motor wire19)Tighten the two socket bolts to the specified torque [2] SOCKET BOLT (2) 4.4 N-m, (0.45 kgf-rn, 3.31bfwft)
[I] CLIP BRACKET
[31 OIL TANK
TORQUE: 4.4 m(0.45 kgfem,3.3 Ibf ft)
WIRE BAND CLIP
eATF FILLING
1) Using syringe or equivalent tool, add approximately 30 cm3 (1.O1 US 02, 1.06 Imp 02) of ATF slowly through the oil filler port of the oil tank2) After adding ATF, tighten the manual valve securelyWipe up any spilled ATF thoroughlyBe sure that the oil hole cap bolt is not tightened3) Connect fully charged battery, power tilt relay, power tilt