Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 331Get this manual
15) Route the power tilt motor wire harness and control box wire harness and secure the wires with the wire band clipCover the motor and switch wires with the corrugated protector as shown16)Route the power tilt motor wire harness along the main wire harness as shown and wrap the wires with the upper and lower spiral protectors as shown17)Secure the wires with the wire clampsCORRUGATED PROTECTOR Set the corrugated protector so that its end is approximately mm above the end of the connector bracket 6 PI
111 CONNECTOR BRACKET B