Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 329Get this manual
6) Set the motor wire grommet to the power tilt motor wire harness and install them to the left stern bracket by aligning the boss of the grommet with the groove of the left stern bracket
[I] GROOVE
7) Apply grease to the 22 mm wave washer and distance collar, then install the wave washer, distance collar and left stern bracket8) Loosely install new 718-14UNF self-locking nut
9) Install the mm washer and mm self-locking nutTighten the mm self-locking nut to the specified torque
TORQUE: 21 am (2.1 kgf m, 15 Ibf10)Tighten the 718-14UNF self-locking nut to 40 (4.1 kgf am,30 Ibf eft) then loosen 1I2 turn11)Install the adjusting rod and tilting bolt caps12)Install the anode and tighten the 12 mm flange bolt securely if the anode removed[41 POWER TILT MOTOR WIRE