Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 270Get this manual
4) Route the battery cables 111
BAlTERY AL,
21 mm TERMINAL NUT
5) Tighten the battery cable ground terminal to the cylinder block using the 12 flange bolt
6) Connect the battery cable positive terminal the starter magnetic switch and install the terminal nutAdjust the terminal direction shown and tighten the terminal nut to the specified torqueTORQUE: 6.5 (0.65 kgfem, 4.7 lbf4t)
7) Clamp the battery cable and charge coil wire with the wire band on the starter magnetic switch
8) Route the battery cable (fuse line) as shown, secure it with the wire bands and lap the wires with the spiral protectors9) Connect the white wire connectors and set them on the connector holder on the starter case B10) Set the fuse holder the fuse holder bracket and secure the wires as shown