Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 265Get this manual
13) Install the rear housing and align the index mark on the rear housing with the index mark on the yoke14) Apply oil to the new O-rings and install the set plate and the O-ring to each through bolt 111 INDEX MARKS
15) Tighten the through bolts securely16) Install the collars and starter magnetic switch and tighten the 18 mm flange bolts to the specified torque
TORQUE: N-m (0.7 km, 5.1 IbfW
17) Install the starter cord between the brush terminal and starter magnetic switch terminals and loosely install the mm terminal nuts18) Adjust the starter cord terminal direction and tighten the terminal nuts to the specified torque