Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 254Get this manual
14) Install the grip rubber with "A" mark facing up 111 GRIP PI
15) Tighten the 12 mm flange bolt securely
16) Lap the spiral wire protector around the throttle cable and switch wires as shown
5INSTALLATION
1) Set the tiller handle assembly on the oil case and loosely tighten the 10 50 flange bolts
EMERGENCY STOP SWITCH WIRE
2) Pass the throttle cable and switch wires through the oil case hole and set the oil case grommet securely