Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 251Get this manual
Ilnstall the oil case grommet to the tiller handle bracket, then install the switch wires and throttle cable through the oil case grommetIf the starter switch was removed from the starter switch housing; before installing it on the oil case grommet and tiller handle bracket, install the starter switch the starter switch housing (P75-61[ II SWITCH WIRES AND THRonLE CABLE
121 OIL CASE GROMMET
TILLER HANDLE BRACKET
2) Install the tiller handle bracket to the tiller handle
3 lnstall the handle pivot bolt and washer, and tighten the rnm self-locking nut to the specified torqueTORQUE: N-m (0.8 kgfm, 5.8 lbf=ft)