Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 225Get this manual
7) Remote control type; connect the link rod to the shift shaftInstall the washer and new cotter pin, spread the ends of the cotter pin as shownTighten the shift arm pivot bolt securely
121.7 mrn WASHER
[312 rnrnCOlTER PIN
81 Set the shift shaft in the reverse position as shown
151 PIVOT BOLT
141 SHlm LINK ROD
9) Turn the lock nut on the shift rod to obtain (0.3 in1 from top of the shift rod to top of the lock nut as shown10) Make sure that the shifi rod is in reverse position and connect the shift rod the shift rod by threading the adjusting nut until the adjusting nut comes in contact with the lock nut
121 LOCK NUT
131 ADJUSTING NUT
11) When the adjusting nut contacts the lock nut, tighten the lock nut by holding the adjusting nutTORQUE: N-rn (I kgf-mlbf-ftl .O