Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 139Get this manual
12) Install the bracket with the 14 mm flange bolt, and then install the ignition control module and connector bracket using the two 25 flange bolts131 Connect the pulse generator wire and exciter coil wire
[I CONNECTOR BRACKET
11 BRACKET K31 IGNITION CON-
connectors and set them on the connector bracket
14) Apply grease to the pivot of the throttle lever and connect the throttle cable linkage pivot the carburetor throttle lever15) Place the throttle cable holder by aligning the flange with the space of the lib and mounting boss, and tighten the 14 flange bolt16) Set the starter case in the place and connect the drain tube the starter case