Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 107Get this manual
2) Measure the resistance between the terminals This test can be made with the carburetor installed on the motor Resistance
15.824.2 H
3) Install vinyl tube as shown4) At room temperature, make sure that breath passes through passage5) Connect the 12V battery positive terminal to the Brown white terminal and negative to BlacWgreen terminal for about five minutesThen check that breath does not pass through
VINYL TUBE
[I VINYL TUBE
ePILOT SCREW REPLACEMENT
Canadian models only: Leave the pilot screw and limiter cap in place during carburetor cleaningRemove only if necessary for carburetor repairRemoval of the limiter cap requires breaking the pilot screwA new pilot screw and limiter cap must be installed1) When the limiter cap has been broken off, remove the broken pilot screw