Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 82Get this manual
dBUSHING REPLACEMENT (S and types) IRemove the water seal (P4-14)[I] DRIVER, 1513 30 mm
2) Set the tools as shown, and press out the bushing using
a hydraulic press3) Apply gear oil to the outside of the new bushing and set the bushing and tools as shownPut the bushing on the impeller housing with the end gap facing to the shift rod side as shown41 Press in the bushing using hydraulic press
[31 END GAP
TOOLS: Driver, 7513 30 mm Pilot, 13 mrn 5) Install new water seal (P4-74)
SHIK SHAW B
DRIVER, 1573 30 mm
PILOT, 13 mm
eNEEDLE BEARING REPLACEMENT (XL type1
1) Remove the water seals (P.4-14)2) Remove the needle bearing using the bearing remover