Honda BF8, BF9.9 and BF10 Outboard Motors Shop Manual., Page 75Get this manual
3) Push the shift spring with screw driver and install the 30 mm shifter pin 111 4x3Omm SHIFrER PIN b4) lnstall the cross pin ring
[I1 CROSS PIN RING
5) Apply marine grease to the water seal lips6) lnstall the reverse bevel gear to the ball bearing inner race of the propeller shaft holder
[I PROPELLER I
SHAm HOLDER
121 REVERSE BEVEL GEAR
7) lnstall the thrust washer onto the propeller shaft, then
install them into the propeller shaft holder
8) lnstall the shift slider
hINSTALLATION
Ilnstall new O-ring to the propeller shaft holder2) Apply marine grease to the O-ring and mating surfaces of the propeller shaft holder and gear case