Honda BF50 (5HP), BF5A Outboard Motors Shop Manual 2014, Page 67Get this manual
BFI5C BFI5A
12PROPELLER SHAFTGEAR CASE
aDISASSEMBLYASSEMBL Y
PROPELLER
6004 BALL BEARING Hold the propeller shaft holder with vise or other holder, then pull the bearing off the propeller shaft holder using the Bearing Remover20 mm (special tool) INSTALLATION: Apply oil to the outer bearing, then drive the beering into the propeller shaft holder using the special tools
BEARING REMOVER, 20 mm No07938-3710800 BEARING REMOVER WEIGHT No07938-3710200 BEARING REMOVER HANDLE No07938-3710100 DRIVER No07749-0010000 ATTACHMENT 42 47 mm No07746-0010300 PILOT 20 mm No07746-0040500
REVERSE BEVEL GEAR SHIM SHIM SELECTION: P68 BF50F All BF 5A BADS-1 000001-1199999 BF5A BADS-1200001-1701363 BF5A BADS-1701364 to subsequent Reverse bevel gear shims are not used in subsequent BF5A unitsPROPELLER SHAFT HOLDER SHEAR PINCOTTER PIN INSTALLATION: Always use the HONDA part (stainless steel)Align the hole in the pro peller ClP with the hole in the propeller shaftPROPELLER CAP PROPelLER INSTALLATION: Check that the shear pin is properly positioned in the groove in the bushingApply grease to the water seal lipDrive new water seal into the propeller shaft holder with the lettering facing in the direction of the propeller, using the special tools