Honda BF50 (5HP), BF5A Outboard Motors Shop Manual 2014, Page 31Get this manual
BF50SF5A
3CARBURETORFUEL PUMP
aDtSASSEMBL YREASSEMBL Y
CARBURETOR INSULATOR THROTTLE ROD ;"'R-E-A-S-S-E-M-B-L- -:REASSEMBLY: Note the installation directionPass the rod through the hole in the throttle rod holder after installing it on the throttle arm on the carburetorADJUSTMENT: P21-22 CABLE HOLDER REASSEMBL Y: Align the groove with the tab on the air guideCHOKE CABLE REASSEMBL Y: Connect the cable end to the choke arm, then push the cable sheath into the air guide slot as far as it will go, and secure with the cable holder
VIEW FROM CARBURETOR SIDE
THERMOSTAT INSPECTION: P.32 REASSEMBL Y: Install with the small hole in the thermostat toward the water passage side as shownWATER } PASSAGE
FUEL TUBE (3.5 165 mm) REASSEMBL Y: After installing the carburetor, insert the tube into the drain hole in the engine housing6 34 mm SPECIAL BOLT (2)