Honda BF35A-BF45A Outboard Motors Shop Manual., Page 379Get this manual
dINSTALLATION Install the long tiller handle assembly to the motorInstall the 10 mrn washers and tighten the 10 mm self-locking nuts to the specified torque
TORQUE: 34 Nm (3.5 kgf-m, 25 Ibf-ft)
Pass the long tiller handle wire harness through the under case grommet, and secure it with the wire harness clampSet the control cable setting plate into the groove of the under case
Pass the control cables through the under case grommet and set the control cables by aligning the groove of the control cable with the cutout of the control cable setting plateAdjust the control cables (throttle control cable length: P3-6, shift control cable length: P3-8)Connect the control cables to the shift arm and throttle arm with the mm plain washers and mm lock pins