Honda BF35A-BF45A Outboard Motors Shop Manual., Page 378Get this manual
CONTROL CABLES, UNDER COVER Install the cable holder as shown noting the installation direction and tighten the 12 mm bolt washer to the specified torque
TORQUE: 0.7 N-m (0.7 kgf-m, 5.1 Ibf43) Apply grease to the link pins of the throttle arm and shift arm, then connect the throttle cable and shift cableSet the shift cable by aligning the groove of the cable with the cutout of the mounting pointSet the throttle cable by aligning the groove with the cutout of the cable holderRoute the throttle and shift cable through the grommet (upper hole: shift cable, lower hole: throttle cable) holes and set the grommet in the case correctlyPower trimltilt type only:Check whether the power tilt switch wire does not interfere with the throttle cableTighten the cover screw to the specified torqueTORQUE: 2.2 Nm (0.22 kgf'm, 1.6 Ibf-ft)