Honda BF35A-BF45A Outboard Motors Shop Manual., Page 373Get this manual
Loosen the lock nut fully and screw the cable pivot as shownTighten the lock nut to the specified torqueTORQUE: 1.3 Nm (0.1 kgfem, 0.9 Ibfeft) Apply grease to the sliding surfaces of the cable pivotApply grease to the pivot point of the throttle arm, then install the throttle rod with the two 10 rnm washers and mrn w-clipPower trimltilt type only: Check whether the power tilt switch wire does not interfere with throttle rod r[I] LOCK NUT
910 mm (0.35 0.39 in)
10 mrn WASHER (2)
[2] THROTTLE ROD
9 mm E-CLIP