Honda BF35A-BF45A Outboard Motors Shop Manual., Page 371Get this manual
POWER TRIMITILT SWITCH Power trimltilt type only: Install the power tilt switch so that the "UP" mark is at the bracket bolt installation hole side (lower side) as shown, and install the switch grommet noting the directionPower trimltilt type only: Replace the wire band with new one, if it has been cutAfter securing the wires with new wire band, cut the end of the wire band so the projected end length is 1020 mm (0.40.8 in)Tighten the 10 mm hexbolt to the specified torque
[2] POWER TRIMITILT