Honda BF35A-BF45A Outboard Motors Shop Manual., Page 337Get this manual
THROTTLE CAMIDASHPOT DIAPHRAGM Place the dashpot diaphragm on the intake manifold, and loosely install the 16 mm torx bolts, Apply grease to the sliding surface of the 6.7 12.5 24 mm collar and install itInstall the opener cam return spring by aligning the hook with the boss of the intake manifoldInstall the throttle opener cam by aligning the hole with the dashpot diaphragm rod end and the groove with the opener cam return spring end
I TORX BIT T30H [I1
(Commercially ava
6x16mrn TORX BOLT (2)
DASHPOT DIAPHRAGM
Align the point "A" of the assist spring with the groove in the throttle camSet the projection of the assist plate in the hook of the assist spring and align the flat surface of the throttle cam with the tab of the assist plateInstall the throttle cam, assist spring and assist plate on to the collar as an assemblyInstall the mm washer and tighten the 40 mm flange bolt to the specified torqueAfter assembly, adjust the dashpot diaphragm (P34)[I61 mm WASHER 1I THROTTLE CAM [I51 THROTTLE CAM 40