Honda BF35A-BF45A Outboard Motors Shop Manual., Page 196Get this manual
11I SNAP RING DtSASSEMBLY: Hold the armature upright, place an offset wrench over the stopper piece and push the stopper piece down exposing the snap ringRemove the snap ring; then remove the stopper piece and clutchSNAP RING
1 INSPECTION: P16-10 1
OVERRUNNING CLUTCH
[41 6003 BALL BEARING
E FRONT COVER
INSTALLATION: P16-1 I
STOPPER COLLAR
STARTER MAGNETIC SWITCH CABLE REASSEMBLY: Connect the starter magnetic switch cable at the angle of 45O from the vertical line as shown
REASSEMBLY: Check for smooth movement in axial direction by rotating the clutchCheck the gear teeth for wear or damage; replace if necessaryAlso, check the flywheel ring gear teeth if the pinion gear teeth are damaged