Honda BF35A-BF45A Outboard Motors Shop Manual., Page 181Get this manual
6) Make sure that the shift link on the outboard motor side is and that the control lever at the in the neutral position (N), remote control box side is in the neutral position (N) 7) Apply marine grease to the pins of the shift pivot8) Connect the control cables to the shift link and throttle arm using mm washers and lock pins as shownTighten the lock nuts securelyNOTE
Use the mm washers on both side of the arm as shownIf the holes in the shift link and the pivot pin do not align, adjust by turning the shift pivot in or out, as required
9) Connect the remote control wire harness to the outboard motor side wire harness and set the connector to the holder10) Secure the remote control wire harness with the harness clip
1 1) Reinstall the separate case and tighten the bolts securely
CONTROL CABLE LENGTH ADJUSTMENT
THROTTLE CONTROL CABLE
1) Disconnect the throttle control cable from the throttle arm