Honda BF35A-BF45A Outboard Motors Shop Manual., Page 179Get this manual
REMOTE CONTROL CABLE INSTALLATION REMOTE CONTROL BOX SIDE
1Remove the screws and housing C
2) Screw the lock nuts and eye ends more than (0.3 in)
onto the thread of the remote control cable and tighten the lock nut securely hold the pivotApply marine grease the hole of the eye end
[I CONTROL CABLE
MORE THAN mm (0.3 in)
[51 LOCK NUT
1 (MARINE 3
3)Install the shift control cable by aligning the groove of the
control cable with the cable guide plateThen connect the eye end the shift arm pin using the washers and lock pin
[I1 REMOTE CONTROL HOUSING [81 mm LOCK PIN 171 WASHER 161 THROTTLE CONTROL CABLE