Honda BF35A-BF45A Outboard Motors Shop Manual., Page 133Get this manual
bINSTALLATION
1Install the propeller shaft holder assembly with the "UP" mark facing upward
[ 1I PROPELLER
SHAFT HOLDER
2)Install the claw washer and aligning it cutout and the tab
of with the projection and the groove of the gear case
111 CLAW
3)Apply grease the end nutSet the gear case end nut in
the gear case with the "OFF" mark the gear case end nut facing outTurn the end nut counterclockwise when the end nut contacts the threaded portion in the gear case, then tighten the nut by turning it clockwise by handNOTE