Honda BF20A-BF25A, BF25D-BF30D Outboard Motors Shop Manual., Page 366Get this manual
1) Remove the outboard motor cover 2) Pass the battery cable, throttle control cable, shift control cable and the control box side wire harness through the grommet, and install the grommet in the outboard motor3) Install the clamp plate aligning the cutouts in the clamp plate with the grooves in the throttle control cable and shift control cable
6) Install the separator cover with the bolts and washers6 28 mm BOLT (2)
SEPARATOR COVER
SHIFT CONTROL CABLE
WASHER (21
6 45 mm BOLT (2)
') Install the pivot shift on each control cable, and