Honda BF20A-BF25A, BF25D-BF30D Outboard Motors Shop Manual., Page 363Get this manual
7)Assemble the neutral lock block with the control housing and tighten the two screwsTorque: N-m (0.2 kgf-m, 1.4 Ibf-ft) NEUTRAL LOCK BLOCK
10)Tighten the housing cover with the two screws Torque: (0.2 kgfm, 1.4 Ibf-ft)
NOTE: Set the switch wire grommet by aligning it with the cutout in the control housing (Power trimltilt
type)Do not overtighten the screws
8) Connect the switch wire connector (Power trimltilt
9) Set the power tilt switch harness as shownInstall the hold-down plate and tighten the two screws (Power trimhilt type)HANGER