Honda BF20A-BF25A, BF25D-BF30D Outboard Motors Shop Manual., Page 353Get this manual
STEERING HANDLE BRACKET INSTALLATION 1) Turn the outboard motor either to the right or left and set the steering handle bracket end over the 10 mrn stud bolts on the mount frame2) Install the two 10 mm washers and two 10 mm self locking nuts on the outboard motor and tighten the self-locking nuts to the specified torqueTORQUE: 34 N-rn(3.5 kgfm, 25 Ibf-ft)
STEERING FRICTION INSPECTION1 ADJUSTMENT
1) Set the friction lever in the lock position (i.emove
fully to the left until it contacts the stopper)
2) Apply the load of 100 (10.0 kgf, 22.05 lbf) to the
center of the long tiller handle throttle grip, and be sure that the long tiller handle does not moveSTOPPER
8 mm SELFLOCKING
STEERING HANDLE BRACKET
FRICTION LEVER