Honda BF20A-BF25A, BF25D-BF30D Outboard Motors Shop Manual., Page 172Get this manual
HONDA FOA25A
8) Make sure that the shift arm on the outboard motor side is in the neutral position (N), and that the control lever at the remote control box is in the neutral position (N)9) Apply marine grease to the pins of the shift pivot10) Connect the control cables to the shift link and throttle arm using mm washers and lock pins as shownTighten the lock nuts securely
REMOTE CONTROL CeBLE [Shift sidel
6 mm WASHER (4I
Use the mm washers on both sides of the arm as shownIf the holes in the shift link and the pivot pin do not align, adjust by turning the shift pivot in or out, as requiredThe pivot pin on the shift control cable must point inward while the pivot pin on the throttle control cable must point outward11) Install the four bolts, two washers, and separate top cover
REMOTE CONTROL CABLE [Throttle sidel
[CARBURETOR THROTTLE LEVER
121 STOPPER
141 POSITION
FULLY-OPEN [51