Honda BF15D BF20D Outboard Motors Shop Manual., Page 410Get this manual
7Assemble the neutral lock block with the control housing and tighten the two screwsTorque: N.m (0.2 kgf.m, 1.4 Ibf.ft) NEUTRAL LOCK BLOCK
10Tighten the housing cover with the two screws
(Power tilt type)Torque: N-m (0.2 kgf-m, 1.4 Ibf.ft) NOTE: Set the switch wire grommet by aligning it with the cutout in the control housing (Power tilt type)Do not overtighten the screwsSCREWS
CONTROL HOUSING B
POWER TILT TYPE: SWITCH WIRE HOUSING COVER C
8Connect the switch wire connector (Power tilt type)9Set the power tilt switch harness as shownInstall the hold-down plate and tighten the two screws (Power tilt