Honda BF115A, BF130A Outboard Motors Shop Manual., Page 445Get this manual
Bolting Motor to Transom With motor resting on the boat transom, verify correct motor heightMotor can be raised by using lower set of mounting holesApply silicone sealant or equivalent to the outside of the mounting bolt holesSecure motor by installing bolts from the boat sideTighten the self-locking nutsThe bolts must have sufficient thread length to tighten down and have at least two or three threads past the end of the self-locking nutTORQUE: Mounting bolt: 40 ft-lb (54 N-m)
Steering Link Arm Installation
The steering link arm must be secured between the steering arm and steering cable using the bolt, washers, nuts, and collar shown belowBoth the bolt and self-locking nuts, used at each end of the steering link arm, must be in good conditionInstall and tighten hardware as follows: 1Install bolt, washer, and collar into link armRemove access grommet from inside engine cover area and thread bolt into steering arm inside holeTighten bolt then tighten lock nutDo not use forward holeTORQUE: 38-24 UNF bolt: 38-24 UNF lock nut: