Honda BF115A, BF130A Outboard Motors Shop Manual., Page 411Get this manual
OREVERSEBEVEL GEAR BACKLASH LCD and XCD types only Reverse bevel gear backlash adjustment must be made before adjusting the forward bevel gear backlash (P12-15)Remove only the bearing holder assembly from the propeller shaft holder (P.12-19 of the base shop manual), and adjust the reverse bevel gear backlash1) Hold the propeller shaft securely with the special tool as shown, and tighten the puller bolt (special tool) the specified torqueTORQUE: N-rn (0.5 kgf-m, 3.6 Ibf-ft) Turn the vertical shaft 10 turns clockwiseTOOLS: Puller jaws Puller bolt JAWS 2) Attach the special tool to the vertical shaft as shown, and adjust the dial gauge so its needle is at line "2" of the special tool3) Turn the vertical shaft lightly right or left and record the dial gauge readingMeasure the backlash at the four points (by turning the vertical shaft 90') in the same manner
[I] PROPELLER SHAFT HOLDER
14 BACKLASH INDICATOR TOOL
[3IPULLER BOLT 07SPC-ZW0011Z