Honda BF115A, BF130A Outboard Motors Shop Manual., Page 330Get this manual
HONDA BF115A-130A
5POWER TILT MOTOR ASSEMBLY
aDISASSEMBLY
1) Untape the varnished teflon tube, and pull the tube to the
VARNISHED TEFLON TUBE
connector side
2) Remove the 16 screwPull out the wire holder and
the two grommets from the yoke assembly, and move them to the tube sideNOTE: Pull out the grommets with care not to damage them
3) Remove the two 16 screws (P14-24)
4) Wrap the armature shaft with shop towel or equivalent material to protect, and hold the shaft with pliers
Pushing the two motor wires toward the yoke assembly, remove the armaturelfront bracket assembly from the yoke assembly5) Remove the armature from the front bracket
121 FRONT BRACKET
1 YOKE ASSEMBLY 3
1 Do not allow the commutator to become contaminated 1