Honda BF115A, BF130A Outboard Motors Shop Manual., Page 328Get this manual
HONDA BFI15A-130A
4) Remove the oil tank cap and check whether the Automatic Transmission Fluid (ATF) is at the upper limit of the filler port (P14-17)5) Push the "DN" side of the power tilt switch to compress each rod fully
6) Push the "UP" side of the power tilt switch to extend each rod fully again, and measure the lower chamber blow pressure
Lower chamber blow oressure
8,82611,768 kPa (90120 kgfcm2, 1,2801,707 osi)
7) If sharp pressure drop is observed, check the power tilt motor for damaged oil seal (f? 14-24)If the blow pressure is lower than the specified pressure, check for oil leaks8) Measure the upper chamber blow pressure
Upper chamber blow pressure 1) After measuring the lower chamber blow pressure, remove the special tool (oil pressure gauge joint B) and the pressure gauge with each rod fully extended2) Tighten the upper chamber special tool (oil pressure gauge joint A)TORQUE: N-m (0.9 kgfam, 6.5 Ibf-ft)