Honda BF115A, BF130A Outboard Motors Shop Manual., Page 325Get this manual
HONDA BF115A-130A
cAIR BLEEDING
Power trimtilt assembly not mounted on the outboard motor-
Bleed air from the unit whenever the power trimttilt assembly is disassembledBe sure to perform the air bleeding in the following orderAir bleeding without mounting the unit on the outboard motor; Check on blow pressure;Air bleeding after mounting the unit on the outboard motorConnect each cable to operate the power trimttilt assembly
2P CONNECTOR
- Connect the positive (+) and negative (-1 starter cables (P178)
- Connect the power tilt motor 2P connector to the power tilt
- Be sure that the starter cables are connected to the battery1) Hold the power trimltilt assembly vertically2) Push the "DN" side of the power tilt switch to compress each rod fully