Honda BF115A, BF130A Outboard Motors Shop Manual., Page 273Get this manual
5) Place the wood block on the gear face of the forward bevel gear6) Set the bearing holder assembled in the step on the forward
[21 50 82 21.5 TAPER 131 BEARING (INNER PRESS
WOOD BLOCK
bevel gear7) Apply gear oil to the inner surface of the taper bearing (inner
race), and set it on the forward bevel gear8) Using the hydraulic press, set the inner race on the forward bevel gear while applying gear oil between the inner race and the outer race of the taper bearings
Adjust the reverse bevel gear backlash with the bearing holder assembly in the condition that it is before tightened against the propeller shaft holder (but the thrust bearing, bearing washer and the thrust shim are mounted) (P1244)9) Set the bearing holder assembly assembled in the step on the propeller shaftLoosely tighten the bearing holder assembly against the propeller shaft holder by handBe sure that the thrust bearing, washer and the shim are properly mounted before installing the bearing holder assembly on the propeller shaft
[41 WOOD BLOCK