Honda BF115A, BF130A Outboard Motors Shop Manual., Page 249Get this manual
HONDA BF115A-130A
CONNECTING ROD BEARING OIL CLEARANCE
1) Wipe the oil off the crank pin and the connecting rod bearing mating surface111 CONNECTING
2) Set the plastigauge on the crank pinSet the connecting rod and cap by aligning the alignment marks on the connecting rod and the cap (P.11-10)
CONNECTING ROD CAP
3) Tighten the connecting rod bolts to the specified torque
4) Mark each of the connecting rod bolts and the connecting rods as shownTighten the connecting rod bolts additionally until the two marks align (go0)TORQUE: 20 N'm (2.0 kgfom, 14 Ibf'ft) Set the plastigauges axiallyTighten the two nuts equally while holding the crankshaft not to turn