Honda BF115A, BF130A Outboard Motors Shop Manual., Page 248Get this manual
HONDA B 15A-130A
CRANKSHAFT MAIN BEARING OIL CLEARANCE
1) Set the crankshaft main bearings on the crankcase and the cyinder blockWipe the oil off the main bearing surface2) Wipe the oil off the crankshaft main journal, and set the crankshaft on the cylinder blockSet the 40 52 rnm oil seal, 98 80 10 mm oil seal and the two thrust washers on the crankshaft3) Place the plastigaugeson the main journal of each crankshaftInstall the crankcaseAlign the 18 22 dowel pins and the ten 13 20 dowel pins between the crankcase and the cylinder block securelySet the plastigauges axially
111 PLASTIGAUGES
[I1 11x131 mm BOLT-WASHER (10)
4 Apply engine oil to the seat and the threads of each bolt,
and loosely tighten them in the positions shownThen, tighten the bolts in the numbered sequence shown in two or three steps to the specified torque
TORQUE: 51 N-m (5.2 kgfm, 38 Ibfeft) (11 131 bolt-washer) 47 Nm (4.8 kgfom35 Ibf4t) (10 40 flange bolt) 39 N=m(4.0 kgf-m, 29 (10 55 flange bolt)