Honda BF115A, BF130A Outboard Motors Shop Manual., Page 234Get this manual
HONDA, BF115A130A
4BALANCER BEARING REPLACEMENT
Dismount the cylinder block as single unit and place it on firm level surface with the crankcase-mating surface toward UP-
Removalinstallationshould be made for each bearing one after anotherRemove each bearing from the flywheel side to the timing belt sideInstallation must be made from the timing belt side to the flywheel sideThe balancer bearing removal mounted on the cylinder block can be made in the same manner by changing the attachment size and the installation position- -
REMOVAL:
1) Remove the two 30 mm sealing bolts from the cylinder block2) Install each special tool as shown
[I]BALANCER BEARING REPLACEMENT TOOL 07WPF-ZW50100 1I BEARINGS
When the balancer bearings are removed successively, pass each attachment on the shaft without securing themNote that each shaft and attachment are stamped with the work code near the stopper pin holeCode and Work Code A-RE B-RE Work No.1 bearing removal No.2 bearina removal