Honda BF115A, BF130A Outboard Motors Shop Manual., Page 186Get this manual
HONDA BFII 5Ae13OA
5) Connect the positive (+) starter cable to the starter solenoid at an angle of and tighten the hexnut to the specified torqueTORQUE: 10.8 N=m(1.1 kgfem, Ibfftl STARTER
6) Connect the positive (+I starter magnetic switch terminal wire to the starter magnetic switch at an angle of 20' with the
caulking part of the terminal toward youl the hexnut to the specified torque
111 POSITIVE (+I STARTE MAGNETIC SWITCH TERMINAL WIRE
TORQUE: 4.9 N-rn (0.5 kgfern, 3.6 lbf4CI
Install with the caulking pa toward you
7 Connect the starter cable 30A fuse connector and the 10A
fuse connectorSet the IP connector between the ribs of the ECM case by turning the connector 180' as shown, and set the wire between the ignition coil suspension and the ribSet the IOA fuse connector between the lower rib of the ECM case and the ignition coil suspension